People offer how to make a good cooling tower service Jacksonville fl. A cooling tower is a heat extraction device that extracts unwanted heat and sends it into the atmosphere, cooling the flow of hot water in the tower. The maintenance procedure is as follows:

Cooling procedure of the tower:

Service areas: Then inspect all the visual parts,

• putty
• engine
• towers
• Blinds
• Nozzles
• Bearings
• Fan motor
• lubrication
• Suction screen
• Engine leveling
• Fog eliminators
• Construction of towers
• Belts and pulleys
• Water float switch
• Engine mounts and fan blades

Methods and maintenance procedures:

The cooling tower needs a well maintenance procedure, as well as adequate methods and instructions. To see all the details in the cooling tower jacksonville fl, you must inspect and verify that all components have a good operating mode and are in safe mode. Make sure that all nozzles flow well through the water. Wash all the powder on the scale, wash, fill and spray the nozzles. If any part needs to be adjusted, replaced or repaired, turn it on immediately if necessary.

Check and adjust the bearings and drive belts. Check the performance and condition of the motor, and the temperature, and make sure that all signals appear to vibrate to ensure a long-lasting analysis. Observe and apply the proper methods for lubricated areas, which should be indicated in the manufacturers’ recommendation.

Check that all parts are well worn and place all bolts and parts so that they are securely fastened and secured. The coupling of the motor must provide an efficient exchange of torque, as well as the correct location for the service of the cooling tower.

This should be a physically clean screen on all components. Check the correct operation of the machine in manual mode. Check for excessive vibration in motors, fans and pumps. Adjust and repair all loose fuel refueling, connections, leaks, if any, continue to inspect and adjust all belts and pulleys.

All maintenance work requires workers to wear respirators, gloves and protective clothing to avoid exposure to bacteria. Each cooling tower can contain bacteria. Therefore, take precautions before starting maintenance work.

Types of cooling towers:

• Open cooling towers (straight)
• Cooling towers closed (indirect)

For the operation of a direct cooling tower, 30,000 to 50,000 m3 of air are required to activate the cooling methods. An indirect cooling tower jacksonvillefl requires only a limited amount of air. Operating costs for a direct cooling tower require three times more energy, and an indirect cooling tower requires much less than the required energy. The total energy consumption is 560 kW of a rotating drum in a direct cooling tower and 283 kW of chilled water in an indirect cooling tower jacksonville fl.